Posts

Chosen Solution Car will start but won’t take gas when press on accelerator, what may be the problem Kelly Royal since you already replaced the engine and transmission, there could be plenty of reasons for the why. I’d start with checking the fuel supply lines and fuel filter. If you have the tools you can also check the fuel pressure. Check your throttle body to see if everything is functioning properly....

Chosen Solution Hello, I’ve had my PS3 fat for a couple years. One day when I tried getting on it, I put in a disc to play it and when I was done with it, I tried to take the disc out (which it did) but the blue light stayed on. What could I do for I can get it back working? Most likely it’s your BR drive acting up, for a quick fix you can try resetting the internal mechanism in the correct position, there’s a trick to automatically calibrating it without having to open up the console: once you get to the XMB menu screen, press and hold the eject button for 12 seconds....

Chosen Solution What could be the problem Betty Jeans Creole Cuisine , If electric grille the cord could be burnt off inside the grille creating a bad connection. If you can disassemble grille to access cord to look at the connection and repair as necessary. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.

Chosen Solution My ps vita slim will not charge or switch on. I have tried other chargers still no response. i think it is the charging port that might be broken then, first try look inside of it to see if it is not like it should be, if everything looks fine then you could try to make a factory reset… i know it might not be the first thing you might want to do, but i had a PC VITA (1000) that got stolen, but it had the same problem, and a factory reset helped on the problem, but id it still wont work then there is only one thing to do, and that is to change the charging port/ motherboard :( ....

Chosen Solution Door clicks, control panel lights up and I hear a click when I hit start but nothing! First unplug it for five minutes to allow it to reset. Are you getting any error codes? It also uses 220 volts in the USA and comes in as two 110 volts so one leg may not be hot. Flip the main breaker in your electrical main panel.

Chosen Solution My electric oven is taking over 2 hours to reach 300 degrees farenheit. @amccarthy2 could be a bad thermostats or bad heating elements. We would need to know the exact make and model and see if we can find a tech sheet to further help you with that. You would need a multimeter and/or a thermometer that can measure heat in excess of 500deg F to see if it heat s up and to measure the resistance of the heating coil....

Chosen Solution When I have my fan on the first setting it has a problem when it rotates to the right it squeaks and it kind of wobbles when it rotates. How do I fix this????? That sounds to me like a failing bearing! This seems to be a pretty common problem with this model. Try taking it apart and follow these instructions. It sounds like “most likely it will be coming from the bearing at the top of the blade drum....

Chosen Solution My HP Slate 7 will not turn on after multiple attempts. There are many reasons why this might happen. First, check to see if the device is charged. If that does not work, check out the HP Slate 7 Plus troubleshooting page for more information regarding this issue.

Chosen Solution My keyboard backlight works great manually, but it won’t adjust its brightness automatically in dark environment/low light condition. I tried SMC & PRAM reset, but nothing change. I have sought support from Apple, but still no result. Something might be wrong with your light sensor. Due to how new this computer is, I suggest that you bring it into an Apple Store and see what they say. Yes, I know Apple Stores aren’t typically much help but it never hurts to try....

Chosen Solution My Galalaxy S II phone is stuck in offline (flight) modus. The offline (flight) modus can not be switched off: At start-up phone is already in flight modus (airplane symbol) When pressing power button and choosing “offline-modus” the “offline modus becomes grey” and can not be reversed again. Phone is alwas in flight modus Removing battery with device on for several minutes did not help. Also removing battery with phone off does not help....

Chosen Solution The saw tends to overheat frequently and the motor makes a weird humming sound. What can be done to prevent the overheating? Depending on the age, rebuilding/replacing the bearings or arbor… getting a different saw. If this answer is acceptable please remember to return and mark it. Check the electrical cord. make sure there are no broken strands at either in where it attaches to the drill or at the outlet....

Chosen Solution So recently my JBL Flip’s battery reached 5 years old and it’s not holding much capacity. So I decided to replace it. But was not successful finding a correct battery. So i put it all back together. and attempted to charge it. Red light flashing and unable to charge. Help? Arthur Mixed I am somewhat confused by your question. you said you replaced the battery but could not find a correct one....

Chosen Solution When i try to captuted some photos especially when it is bright or too much light the pictures that will appear in the camera were blurred and a lot of lines. this is an issue with older cameras, as long as you don’t point your camera at the source of light, it shouldn’t be a problem

Chosen Solution I have a Whirlpool Duet Dryer about 12 years old. Recently I replaced the thermosister and heating element and the dryer has run flawlessly for about a month. I get power to the control panel (lights up) but recently the buttons/controls stopped working. The heating element does get hot. I ran the diagnostic and had no issues. Here are some of the strange things happening: When I use timed dry I am unable to adjust the length of time using the buttons....

Chosen Solution So my iPod Nano 6th Gen got white screen of death a while ago.(the screen is white and can’t do anything). I heard about putting it in disk mode and restoring it …and i have to say it worked for a brief period of about 2 minutes. i managed to restore it and it worked until i turned the screen off…after which it went back to being broken. iTunes is recognizing it and all but …white is all i can see… what should i do ....

Chosen Solution My iPad is frozen and has lots of code/message written on the screen … Debugger message: panic The last line is .. Panic: We are hanging here… 116 threads: pid 0: kernel_task Please advise.. thanks try see if this site helps you out https://www.cultofmac.com/152120/how-to-…

Chosen Solution I have a late 2015 iMac I purchased second hand, I upgraded to 512GB NVMe drive and I was installing Montery when the power went off. Now I’m getting no power on and no diagnostic lights.I have checked with two other power supplies which are known to be working but no cigar. The power supply is receiving power. Nothing was shorted and I can’t see any damage. What would have cause this?...

Chosen Solution Here’s the details… no hidden occurrences, I purchased a 2015 MacBook 12" Retina for a trip to Asia. I was traveling extensively via Plane, Train and Boat so I wanted something compact. It arrived used from eBay, but working perfectly. I was in and around China for 1 month and had absolutely zero issues with the unit. I arrived back in the states and still, zero issues. I was leaving for NY for a few days and placed the MacBook on my kitchen table, plugged in to charge....

Chosen Solution i plugged it in and let it charge all the way up when i took the charger out the piece that holds it in came out with it what do i do destenyanndavis14, you did not tell us which tablet you have. It stands to reason that your charging port has either become unsoldered and by pulling the cable you removed it off the board or a charging flex....

Chosen Solution I was editing a video in Premiere and my screen randomly turned grey. When I rebooted, I got the chime and the click touchpad, but also a grey screen. I tried reseting my PRAM, SMC, booting in safe mode, and nothing worked. Then I picked up my laptop and started banging it with my fists. Hard. And now it’s working. This is the second time it’s given me the grey screen recently, the first time no keyboard solutions worked, and the first literally hitting it worked....