Posts

Chosen Solution After having pulleys replaced by a Sears certified repairman, the belt that engages the blades periodically flies off and tangles, slicing the belt, when I attempt to engage the blades. About every third mow. The repairman claims it’s my fault because I don’t clean under the deck every time I mow. He is incorrect. I have gone through seven belts in two years. Try this; when you put the lever on to engage the blade, DO IT SLOWLY and not in heavy grass....

Chosen Solution I have the new power cord from MS when they had the recall (it has a breaker on it). Whenever I hit the power button and breaker trips so it won’t turn on. What’s the problem? It’s a defective cable as well. We had a customer come in with the same problem and we used our cable and the system worked just fine. Try a different plug in as well....

Chosen Solution my drone won’t take off the power on it starts but it just nudges forward how do i fix Hi, What is the make and model number of the drone? Has it worked OK before? If not, have you ensured that the propellers are attached in the correct way i.e. not upside down or in the wrong spot for the particular propeller on the drone? They have to be installed and positioned correctly to get lift and stability....

Chosen Solution Good Morning all, So I got given an iPhone 7 to fix, Basically what is happening is it is getting so hot it causes the iPhone to warn you its got too hot and wait for it to cool down. My first thought something is shorting so let’s rule everything out, I put the board into an iPhone 7 that works perfectly and it still overheated so its a board issue....

Chosen Solution My Ps5 Controller works fine while wired. But Bluetooth connects to my pc a little slow, but it works. Unless I hold it extremely still and close to my pc it will have a continuous input of the last action on the controller. The PC says it remains connected. And if I move it another foot or turn in my chair the led turns red. I tried it with and without windows Ds4....

Chosen Solution My speaker is not conecting to Bluetooth and it doesn’t on light but it bring sound when I on ot Try a hard reset JBL Flip 5 Reset Power on your device.Press and hold the play and the volume + buttons at the same time.Maintain this position for about 5 secs.The device will power off as it restores to the factory default.Power on your Flip 5 again, and it will have restored to the factory default....

Chosen Solution I have the Altec Bluetooth IME579-AB speaker. Why does it stop responding when the Bluetooth setting on my phone shows it still has a 50% charge. Other Bluetooth devices are able to connect to the same phone and continue to work fine. Try connecting it t charger and useing it. If it works that way and doesn’t disconnect then you have a battery indicator that’s out of sync.

Chosen Solution I have a 94 toyota camry le it was driving just fine and it just died on me when i was driving thought i ran out of gas but now it has gas and still no start. I was told there was no spark at the sparkplugs. After new sparkplugs, sparkplug wires, distributor and cap, and a few other things it still wont start. I dont have the money to take to a shop and no one to help at least no one that know what they are doing....

Chosen Solution how to unlock memory card?.changed memory card.says “locked”? Hi. SD memory cards have a physical lock switch on the side of the card. Make sure it is not engaged on the “lock” function. Some memory stick duo cards have a lock switch on the back of the card. These lock switches can sometimes fail and get stuck in locked mode even if the switch is in the unlocked position....

Chosen Solution I’ve built a few Pocket-Colors with success. However, I haven’t had audio in the last two I’ve built. It seems to be down to the C38 capacitor. It only reads 0.008V when powered on. A Pocket-Color conversion requires trimming the bottom portion of the motherboard and makes use of jumper wires to fix the issues of not having a Headphone jack or DC Input. I’ve went back through the original systems I built, found no discrepancy....

Chosen Solution My original ps4 disc drive broke I looked up everything I could do but nothing work I recently just bought a new replacement it worked but the eject button didn’t work so I swapped the logic board and put the original back on then the disc drive stopped working so I put back the logic board it came with but when I went to power it on the power button and eject button both did not work and the disc drive still did not work what do I do...

Chosen Solution My iPhone shows it’s charging but instead of increasing it battery percentage it’s going down what should I do? Consider getting the charging port tested, get a mobile phone repair shop to try another charging port and if that doesn’t help they can try another battery as well.

Chosen Solution The red or magenta color on my hp 6600 comes out looking almost brown. What is the cause. I did a deep cleaning and aligning. Still poor. The only thing the internal procedures ever do is waste ink with no improvement 9 times out of 10, if it doesn’t make things worse. What you need to do is physically remove the printhead and soak it in water. As this is a later HP 900 series machine, the disassembly shown may not apply (only applies to HP 564/901-912 printers), but it is similar enough to make sense - just flip the grey tab holding the printhead up and it’s out....

Chosen Solution lcd screen you must change your lcd you don’t have to change your LCD the problem occurs because of the OS you have to update your phone to the latest customs software version now days the latest OS of Nokia C5-03 is 23.0.015. C01.01. the problem will fix. hi My Nokia C5-03 screen doesnt appear when I switch it on please help email me harthik45@gmail.com

Chosen Solution My FZ18 wont turn on and batteries ( I have 4) are all good. Initially when I put a freshly charged battery in I could take a photo and then the camera would shut down and not start up again so don’t know if it’s immediately discharging battery but now just dead Is there any error message displayed on the camera LCD? When you take a photo, does it say “please turn the camera on and then off again” Or does it immediately shut off?...

Chosen Solution Hi, I would like to purchase a CHEAP AND BEST power supply for mobile servicing. Which one is better and advantageous——DIGITAL OR ANALOG? @kumaran123 “this ““CHEAP AND BEST “ is going to be tough. It should be either or. The best power supply is the one you can afford and that will work for you. If you are short on funding right now use an old PC power supply like a lot of us do....

Chosen Solution This morning I dropped my Iphone 6. Now my touchscreen is unresponsive and there’s white lines up and down the screen. I’ve never attempted to fix a phone on my own but reading some of these threads I see that it could just be that something is loose? Would it be wise to purchase the tools needed to attempt to fix it myself? What do you think the issue is and more importantly do you think it’s fixable at all?...

Chosen Solution I have a Samsung LE32R83B Model no - LE32R83BX/XEU I can’t seem to auto tune the tv / won’t pick up any channels. I have checked the input arial cable at other ports from other working tv’s - still no channels found. I am wondering if i could reset the tv - however the press and holding the exit button for 12 sec isn’t working. Is there an advanced code ?...

Chosen Solution My Asus T-100 running Windows 10 won’t wake up from hibernation. It tells me to swipe to shut down computer and nothing happens. I ran down the battery, plugged in and then recharged. It’s still stuck on hibernate. Any tips for rebooting? Just had this happen to me. I unplugged screen from keyboard the used the power button to turn it back on. Worked fine. Got this on another site....

Chosen Solution It has been sitting in a box for ever and does not turn on it has no damage on it except the battery door which has found it’s way to becoming a dog toy. I have tried two games, batteries, a rechargeable battery pack, and anything the manual suggests to do. It just doesn’t power on, or light the red power light. It has no sign of corrosion anywhere on the unit....