Chosen Solution
Currently searching for assistance on troubleshooting an issue with the Whirlpool Quiet Partner dishwasher. Load will start , without issue; however, after 3 to 4 minutes the dishwasher will stop and the Sani Rinse light begins to blink. Will not continue with wash, can’t seem to reset the load either. After much research, I assume the the model is older, but seems like something that can still be fixed, as the problem seems similar to other posts… Only challenge I am finding is that the troubleshooting tips state to press the Start button (at some point ) but my unit does not have a Start button… not sure how to identify the error. Any suggestions and help would be greatly appreciated! Christina
Try reseting it. Here’s how: Press “Heated Dry,” “Normal,” “Heated Dry,” “Normal” within three seconds of the first pressed button. Now close the door, this should reset your dishwasher. UPDATE Cycle power to the control to reset the dishwasher Much like a computer, resetting your Whirlpool dishwasher’s control panel can sometimes solve the issues you are experiencing. To reset the dishwasher control panel: Disconnect from the power source for one minute. After one minute reconnect the dishwasher to its power source.If your dishwasher is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in.If the dishwasher is hard wired to the power supply, turn the breaker off at the home electrical panel that powers the dishwasher for one minute and then turn the breaker back on.
Most likely bad turbidity sensor. Like a temp sensor but maybe just dirty as well.
