Chosen Solution
My whirlpool dishwasher will fill with water, drain, and countdown, but it will not spray. I had this issue before and I cleared the trouble codes, but that is not working this time. The trouble code I am getting it, E6F6 as well as E-F-. I appreciate the help.
@mjdean we will need to know the exact model for your dishwasher. The F6 E6 (model dependent)is a water temp code that means the incoming water from the house is too cold. It is also possible that it does not detect any incoming water despite the water inlet valve being open. Try and check if this will work for your specific model: Diagnostics Cycle, perform the following while in standby: ■ Press any 3 keys in the sequence 1-2-3-1-2-3- 1-2-3 with no more than 1 second between keys. ■ The Service Diagnostics Cycle will start when the door is closed. ■ To rapid advance 1 interval at a time, press the Start/Resume key. Rapid advancing may skip sensor checks as some checks require 2 complete intervals. NOTE: While in the Diagnostic Cycle, the Start/ Resume feature is turned off (for example, Auto Resume after door interrupts) and the Start/Resume key becomes an interval advance key. ■ Invoking Service Diagnostics clears all status and last run information from memory and restores defaults. It also forces the next cycle to be a sensor calibration cycle. ■ Last run cycles and options returned to default (Normal cycle with Heated Dry option). ■ Last run delay returns to the lowest delay increment. ■ Calibration cycle may force an extra rinse to occur prior to Final Rinse (to assure clear water), then calibrates the OWI and the fill amount during the final rinse. ■ Operating state returns to Standby upon completing or terminating the Service Diagnostics Cycle
